srijeda, 15. listopada 2008.

Sailing terminology


Sailors use traditional nautical terms for the parts of or directions on a vessel; starboard (right), port (left), forward or fore (front), aft (rearward), bow (forward part of the hull), stern (aft part of the hull), beam (the widest part). Vertical spars are masts, horizontal spars are booms (if they can hit the sailor), gaffs (if they are too high to reach) or poles (if they cannot hit the sailor).

Rope and lines

Standing rigging (on the left) and running rigging (on the right), on a sailing boat.
Standing rigging (on the left) and running rigging (on the right), on a sailing boat.

Rope is the term used only for raw material; once a section of rope is designated for a particular purpose on a vessel, it generally is called a line, as in outhaul line or dock line. A very thick line is considered a cable. Lines that are attached to sails to control their shapes are called sheets, as in mainsheet If a rope is made of wire, it maintains its rope name as in 'wire rope' halyard.

Lines (generally steel cables) that support masts are stationary and are collectively known as a vessel's standing rigging, and individually as shrouds or stays (the stay running forward from a mast to the bow is called the forestay or headstay).

Moveable lines that control sails or other equipment are known collectively as a vessel's running rigging. Lines that raise sails are called halyards while those that strike them are called downhauls or cunninghams. Lines that adjust (trim) the sails are called sheets. These are often referred to using the name of the sail they control (such as main sheet, or jib sheet). Sail trim may also be controlled with smaller lines attached to the forward section of a boom; such a line is called a vang, or a kicker in the United Kingdom.

Lines used to tie a boat up when alongside are called docklines, docking cables or mooring warps.

Some lines are referred to as ropes: A bell rope (to ring the bell), a bolt rope (attached to the edge of a sail for extra strength), a foot rope (on old square riggers for the sailors to stand on while reefing or furling the sails), and a tiller rope (to temporarily hold the tiller and keep the boat on course). A rode is what keeps an anchor attached to the boat when the anchor is in use. It may be chain, rope, or a combination of the two.

Other terms

Sailboat on a mooring ball near Youngstown, NY
Sailboat on a mooring ball near Youngstown, NY

Walls are called bulkheads or ceilings, while the surfaces referred to as ceilings on land are called 'overheads'. Floors are called 'soles' or decks. The toilet is traditionally called the 'head', the kitchen is the galley. Lines are rarely tied off, they are almost always 'made fast' or 'belayed.' Sails in different sail plans have unchanging names, however. For the naming of sails, see sail-plan.

Knots

Knots are among the most important things a sailor needs to know. Although only a few are required, the bowline in particular is essential. By also learning the clove hitch and "round turn and two half hitches," one can easily cope with all of the knot requirements of a boat. A more complete grasp of knot-tying includes mastery of the following knots:

Additional knots are available List of knots

Even experienced sailors may forget their knots if they are not performed on a regular basis. Forgetting how to tie an important knot can damage a boat or cause injury.

Nema komentara: